[Sarlug] Вопрос о USB.

[Lortonix]

Здравствуйте!

Вопрос такой, при подключении внешнего винта через USB он не
определяется правильно. А при подключении флешек все работает.

Дистрибутив - Ubuntu Karmic Koala (development branch).

:~$ dmesg
[31560.606232] scsi9 : SCSI emulation for USB Mass Storage devices
[31560.612054] usb-storage: device found at 10
[31560.612058] usb-storage: waiting for device to settle before scanning
[31565.612236] usb-storage: device scan complete
[31565.612716] scsi 9:0:0:0: Direct-Access     ST916031 0AS
       PQ: 0 ANSI: 2 CCS
[31565.613248] sd 9:0:0:0: Attached scsi generic sg2 type 0
[31565.646075] sd 9:0:0:0: [sdb] 312581808 512-byte logical blocks:
(160 GB/149 GiB)
[31565.646817] sd 9:0:0:0: [sdb] Write Protect is off
[31565.646822] sd 9:0:0:0: [sdb] Mode Sense: 34 00 00 00
[31565.646825] sd 9:0:0:0: [sdb] Assuming drive cache: write through
[31565.649195] sd 9:0:0:0: [sdb] Assuming drive cache: write through
[31565.649201]  sdb:
[31565.684078] sd 9:0:0:0: [sdb] Assuming drive cache: write through
[31565.684086] sd 9:0:0:0: [sdb] Attached SCSI disk
[31565.892027] usb 1-3: reset high speed USB device using ehci_hcd and
address 10
[31566.028053] usb 1-3: device descriptor read/64, error -71
[31566.268031] usb 1-3: device descriptor read/64, error -71
[31566.484032] usb 1-3: reset high speed USB device using ehci_hcd and
address 10
[31566.620029] usb 1-3: device descriptor read/64, error -71
[31566.860028] usb 1-3: device descriptor read/64, error -71
[31567.076032] usb 1-3: reset high speed USB device using ehci_hcd and
address 10
[31567.500020] usb 1-3: device not accepting address 10, error -71
[31567.612032] usb 1-3: reset high speed USB device using ehci_hcd and
address 10
[31573.032036] usb 1-3: device not accepting address 10, error -110
[31573.032087] sd 9:0:0:0: Device offlined - not ready after error recovery
[31573.035638] usb 1-3: USB disconnect, address 10
[31573.152037] usb 1-3: new high speed USB device using ehci_hcd and address 11
[31573.288030] usb 1-3: device descriptor read/64, error -71
[31573.528053] usb 1-3: device descriptor read/64, error -71
[31573.744340] usb 1-3: new high speed USB device using ehci_hcd and address 12
[31573.880032] usb 1-3: device descriptor read/64, error -71
[31574.120030] usb 1-3: device descriptor read/64, error -71
[31574.336055] usb 1-3: new high speed USB device using ehci_hcd and address 13
[31574.760021] usb 1-3: device not accepting address 13, error -71
[31574.872030] usb 1-3: new high speed USB device using ehci_hcd and address 14
[31575.296069] usb 1-3: device not accepting address 14, error -71
[31575.296095] hub 1-0:1.0: unable to enumerate USB device on port 3
[31575.628055] usb 3-1: new full speed USB device using ohci_hcd and address 6
[31575.768027] usb 3-1: device descriptor read/64, error -62
[31576.020037] usb 3-1: device descriptor read/64, error -62
[31576.260035] usb 3-1: new full speed USB device using ohci_hcd and address 7
[31576.400029] usb 3-1: device descriptor read/64, error -62
[31576.644261] usb 3-1: device descriptor read/64, error -62
[31576.884030] usb 3-1: new full speed USB device using ohci_hcd and address 8
[31577.292016] usb 3-1: device not accepting address 8, error -62
[31577.428059] usb 3-1: new full speed USB device using ohci_hcd and address 9
[31577.840782] usb 3-1: device not accepting address 9, error -62
[31577.840848] hub 3-0:1.0: unable to enumerate USB device on port 1

В энторнетах предлагают отрубить модуль ehci_hcd, но

:~$ sudo modprobe -r ehci_hcd
FATAL: Module ehci_hcd not found.

Проблема конкретной в моем дистрибутиве, загружался с лайфсиди и
подключал - работает, на других компах также все нормально.
Загружался на других версиях ядра, но результата это не дало.

Есть идеи?

-- 
С уважением, Lortonix!